Removal Procedure
Caution: This vehicle is equipped with a Supplemental Inflatable Restraint (SIR) System. Failure to follow the correct procedure could cause the following conditions:
ā¢ | Unnecessary SIR system repairs |
In order to avoid the above conditions, observe the following guidelines:
ā¢ | Refer to SIR Component Views in order to determine if you are performing service on or near the SIR components or the SIR wiring. |
ā¢ | If you are performing service on or near the SIR components or the SIR wiring, disable the SIR system. Refer to Disabling the SIR System. |
- Disable the SIR system.
Refer to
Disabling the SIR System
in SIR.
- Remove the knee bolster. Refer to
Driver Knee Bolster Replacement
in Instrument Panel, Gages, and
Console.
- Disconnect the electrical connector from the tilt actuator assembly.
- Remove the fasteners (3) from the tilt actuator assembly.
- Remove the tilt actuator assembly (2) from the steering column.
- Remove the Potentiometer housing (1) from the tilt actuator assembly.
- Disconnect the tilt cable
from the tilt actuator assembly.
Installation Procedure
- Install the black end
of the tilt actuator cable assembly to the steering column.
- Install the potentiometer
housing (1) to the tilt actuator assembly (2).
- Install the white end of the tilt actuator cable to the tilt actuator
assembly.
Notice: Use the correct fastener in the correct location. Replacement fasteners
must be the correct part number for that application. Fasteners requiring
replacement or fasteners requiring the use of thread locking compound or sealant
are identified in the service procedure. Do not use paints, lubricants, or
corrosion inhibitors on fasteners or fastener joint surfaces unless specified.
These coatings affect fastener torque and joint clamping force and may damage
the fastener. Use the correct tightening sequence and specifications when
installing fasteners in order to avoid damage to parts and systems.
- Install the tilt
actuator assembly and the retaining screws.
Tighten
Tighten the tilt actuator assembly retaining screws to 2 NĀ·m
(18 lb in).
- Connect the electrical connector to the tilt actuator.
- Install the lower trim cover. Refer to
Steering Column Trim Covers Replacement - On Vehicle
.
- Install the knee bolster. Refer to
Driver Knee Bolster Replacement
in Instrument Panel, Gages, and
Console.
- Enable the SIR system. Refer to
Enabling the SIR System
in SIR.