Step | Action | Yes | No |
|---|---|---|---|
Schematic Reference: Tilt/Telescoping Steering Column Schematics DEFINITION: This table is for a tilt/telescoping steering column system in which only the telescope functions are inoperative | |||
1 | Did you perform the Steering Wheel and Column Diagnostic System Check? | Go to Step 2 | |
2 | Verify that the Telescoping function is inoperative. Does the Telescoping function operate normally? | Go to Testing for Intermittent Conditions and Poor Connections in Wiring Systems. | Go to Step 3 |
3 |
Does the scan tool indicate an Idle state? | Go to Step 4 | Go to Step 6 |
4 | With the scan tool, observe the Telescope Tilt Switch parameter in the Tilt/Telescope Module Data Display list while activating the tilt/telescoping switch to the In and Out positions. Did the parameter change states as expected? | Go to Step 5 | Go to Step 7 |
5 | With the scan tool, observe the Telescope Tilt Output parameter in the Tilt/Telescope Module Data Display list while activating the tilt/telescoping switch to the In and Out positions. Did the parameter change states as expected? | Go to Step 8 | Go to Step 9 |
6 |
Does the scan tool indicate the Idle state? | Go to Step 10 | Go to Step 12 |
7 | Test both of the tilt/telescoping steering column switch In and Out signal circuits for an open or short to voltage. Refer to Circuit Testing and Wiring Repairs in Wiring Systems. Did you find and correct the condition? | Go to Step 16 | Go to Step 9 |
8 | Test the steering column telescope actuator control circuits for a short to voltage or an open. Refer to Circuit Testing and Wiring Repairs in Wiring Systems. Did you find and correct the condition? | Go to Step 16 | Go to Step 11 |
9 | Test the telescope actuator position sensor 5 volt reference and ground circuits for an open. Refer to Circuit Testing and Wiring Repairs . Did you find and correct the condition? | Go to Step 16 | Go to Step 12 |
10 | Inspect for poor connections at the harness connector of the tilt/telescoping steering column switch. Refer to Testing for Intermittent Conditions and Poor Connections and Connector Repairs in Wiring Systems. Did you find and correct the condition? | Go to Step 16 | Go to Step 13 |
11 | Inspect for poor connections at the harness connector of the tilt/telescoping steering column telescope actuator. Refer to Testing for Intermittent Conditions and Poor Connections and Connector Repairs in Wiring Systems. Did you find and correct the condition? | Go to Step 16 | Go to Step 14 |
12 | Inspect for poor connections at the harness connector of the tilt/telescoping steering column control module. Refer to Testing for Intermittent Conditions and Poor Connections and Connector Repairs in Wiring Systems. Did you find and correct the condition? | Go to Step 16 | Go to Step 15 |
13 | Replace the tilt/telescope switch. Refer to Telescope Actuator Switch Replacement - On Vehicle . Did you complete the replacement? | Go to Step 16 | -- |
14 | Replace the telescope actuator. Refer to Telescope Actuator Assembly Replacement - On Vehicle . Did you complete the replacement? | Go to Step 16 | -- |
15 |
Important: Perform the set up procedure for the tilt/telescoping steering column control module. Replace the tilt/telescoping steering column control module. Refer to Steering Column Control Module Replacement . Did you complete the replacement? | Go to Step 16 | -- |
16 | Perform the Steering Column Control Module Programming. Refer to Steering Column Control Module Programming . Did you complete the action? | Go to Step 17 | -- |
17 | Operate the system in order to verify the repair. Did you correct the condition? | System OK | Go to Step 2 |
