For 1990-2009 cars only
- Install the black end of the tilt cable assembly to the steering column.
- Install the white end of the tilt cable assembly to the tilt drive motor assembly.
- Snap on the potentiometer housing. (1).
- Install the tilt drive motor assembly (2) to the steering column.
- Install 2 TORX® head screws (3).
- Connect the connectors of the tilt drive motor assembly (2).
- Install the steering column into the vehicle. Refer to Steering Column Replacement .
- Install the steering wheel onto the steering column. Refer to Steering Wheel Replacement .
- Enable the inflatable restraint steering wheel module. Refer to Enabling the SIR System in SIR.
Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.
Tighten
Tighten the screws to 2 N·m (18 lb in).
Caution: Refer to SIR Inflator Module Coil Caution in the Preface section.
