GM Service Manual Online
For 1990-2009 cars only

Tools Required

    •  J 42578 Steering Wheel Puller Legs
    •  J 1859-A Steering Wheel Puller

Removal Procedure


    Object Number: 255213  Size: SH

    Caution: This vehicle is equipped with a Supplemental Inflatable Restraint (SIR) System. Failure to follow the correct procedure could cause the following conditions:

       • Air bag deployment
       • Personal injury
       • Unnecessary SIR system repairs
    In order to avoid the above conditions, observe the following guidelines:
       • Refer to SIR Component Views in order to determine if you are performing service on or near the SIR components or the SIR wiring.
       • If you are performing service on or near the SIR components or the SIR wiring, disable the SIR system. Refer to Disabling the SIR System.

  1. Disable the SIR system. Refer to Disabling the SIR System in SIR.
  2. Remove the Inflatable Restraint Steering Wheel Module. Refer to Inflatable Restraint Steering Wheel Module Replacement in SIR.

  3. Object Number: 294367  Size: SH
  4. Disconnect the steering wheel electrical connector.
  5. Remove the steering wheel retaining nut.
  6. Install J 42578 and J 1859-A to the steering wheel.
  7. Using J 42578 and J 1859-A remove the steering wheel .
  8. Remove the J 42578 and the J 1859-A from the steering wheel.

Installation Procedure


    Object Number: 294367  Size: SH
  1. Route the wiring through the steering wheel.
  2. Align the splines on the steering wheel with the splines on the shaft.
  3. Install the steering wheel to the steering column upper shaft.
  4. Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

  5. Install the steering wheel retaining nut.
  6. Tighten
    Tighten the steering wheel retaining nut to 41 N·m (30 lb ft).

  7. Connect the steering wheel electrical connector.
  8. Install the Inflatable Restraint Steering Wheel Module. Refer to Inflatable Restraint Steering Wheel Module Replacement in SIR.
  9. Enable the SIR system. Refer to Enabling the SIR System in SIR.