Schematic Reference: Heated Seats Schematics

1

Did you review the heated seat operation and perform the necessary inspections?

Go to Step 2

Go to Symptoms - Seats

Verify that the Heated Seat Switch High Indicator Malfunction complaint is present.

Does the high temperature indicator of the heated seat switch operate as described in the Heated Seats Description and Operation?

Go to Testing for Intermittent Conditions and Poor Connections in Wiring Systems

Go to Step 3

1. Turn ON the ignition, with the engine OFF.
2. Is the HI temperature indicator always on?

Go to Step 7

Go to Step 4

1. Turn OFF the ignition.
2. Disconnect the heated seat switch connector.
3. Connect a 3-amp fused jumper wire from battery positive voltage to the battery terminal of the heated seat switch
4. Probe the high temperature indicator terminal of the heated seat switch with a test lamp that is connected to a good ground.

Does the HI temperature indicator illuminate?

Go to Step 5

Go to Step 9

Test the heated seat high temperature indicator control circuit between the heated seat switch and the door module for a short to battery voltage, a high resistance, or an open. Refer to Circuit Testing and Wiring Repairs in Wiring Systems.

Did you find and correct the condition?

Go to Step 12

Go to Step 6

Test the heated seat back only mode indicator control circuit between the heated seat switch and the door module for a short to voltage. Refer to Circuit Testing and Wiring Repairs in Wiring Systems.

Did you find and correct the condition?

Go to Step 12

Go to Step 8

Test the heated seat high temperature indicator control circuit between the heated seat switch and the door module for a short to ground. Refer to Circuit Testing and Wiring Repairs in Wiring Systems.

Did you find and correct the condition?

Go to Step 12

Go to Step 8

Inspect for poor connections at the harness connector of the door control module. Refer to Testing for Intermittent Conditions and Poor Connections and Connector Repairs in Wiring Systems.

Did you find and correct the condition?

Go to Step 12

Go to Step 10

Inspect for poor connections at the harness connector of the heated seat switch. Refer to Testing for Intermittent Conditions and Poor Connections and Connector Repairs in Wiring Systems.

Did you find and correct the condition?

Go to Step 12

Go to Step 11

Replace the door control module. Refer to Door Control Module Replacement in Doors.

Did you complete the replacement?

Go to Step 12

--

Replace the heated seat switch. Refer to Front Seat Heater Switch Replacement or Rear Seat Heater Switch Replacement .

Did you complete the replacement?

Go to Step 12

--

Operate the system in order to verify the repair.

Did you correct the condition?

System OK

Go to Step 2