For 1990-2009 cars only
Removal Procedure
- Disable the SIR system. Refer to Disabling the SIR System in SIR.
- Remove the seat from the vehicle. Refer to Bucket Seat Replacement .
- Remove the seat cushion in order to gain access to the seat adjuster motors. Refer to Front Seat Cushion Replacement .
- Determine the applicable seat adjuster motor requiring replacement:
- Remove the seat adjuster drive cables from the seat adjuster motor. Refer to Power Seat Drive Cable Replacement .
- Disconnect the electrical connector from the seat adjuster motor.
- Remove the factory motor inserts securing the seat adjuster motor to the seat adjuster motor bracket.
- Remove the seat adjuster motor .
- Remove the factory motor insert to be reused in the installation of the new motor.
Caution: Refer to SIR Caution in the Preface section.
| • | The rear vertical adjuster motor (1) |
| • | The front vertical adjuster motor (2) |
| • | The horizontal adjuster motor (3) |
| 7.1. | On a clean, dry surface lay the seat on its back. |
| 7.2. | Using a 3/16 in drill bit (1), drill the factory motor insert (2) from the bottom side of the motor plate (4). |
Installation Procedure
- Position the seat adjuster motor (1,2,3) to the seat adjuster motor plate.
- Secure the seat adjuster motor to the seat adjuster motor plate.
- Connect the electrical connector.
- Install the seat adjuster drive cables. Refer to Power Seat Drive Cable Replacement .
- Install the seat cushion. Refer to Front Seat Cushion Replacement .
- Install the seat into the vehicle. Refer to Bucket Seat Replacement
- Enable the SIR system. Refer to Enabling the SIR System .
- If the vehicle is equipped with memory seats, calibrate the seat. Refer to Memory Seat Calibration .
| 2.1. | Discard the motor inserts supplied with the new motor. |
| 2.2. | Install the previously drilled out factory motor inserts (2), into the rubber grommet (3) of the new motor. |
| 2.3. | Insert the rivet (1) through the motor plate (4) into the motor insert (2) and secure. |
