For 1990-2009 cars only
Removal Procedure
- Remove the headliner. Refer to Headlining Trim Panel Replacement in Interior Trim.
- Remove the sunroof control module. Refer to Power Sunroof Express Module Replacement .
- Remove the tape (5) securing the electrical harness to the sunroof actuator motor (4).
- Disconnect the electrical connectors (1,3) at the sunroof actuator motor.
- Cut the tie straps securing the electrical harness to the drive cable tube.
- Disconnect the electrical harness from the rear sunroof drain hose retainers.
- Disconnect the electrical connector at the main body electrical harness at the rear edge of the rear shelf panel.
- Remove the electrical harness from the vehicle.
Notice: Note the correct routing of the electrical wiring. Failure to reinstall the wiring properly could result in damage to the wiring.
Installation Procedure
- Connect the electrical connector to the main body electrical harness at the rear shelf panel.
- Secure the electrical harness to the clips on the rear drain hose.
- Connect the electrical connectors (1,3) to the sunroof actuator motor (4).
- Secure the harness to the sunroof actuator motor with new electrical tape (5).
- Connect the electrical connectors to the sunroof control module.
- Install the control module to the sunroof module assembly.
- Ensure the locking tabs are secure.
- Secure the electrical harness to the drive cable tube with 2 new tie straps.
- Verify the operation of the sunroof.
- Install the headliner. Refer to Headlining Trim Panel Replacement in Interior Trim.
