Schematic Reference: Theft Deterrent System Schematics

1

Did you perform the Theft Deterrent Diagnostic System Check?

Go to Step 2

Go to Diagnostic System Check - Theft Deterrent

Important: Ensure that all the doors and the rear compartment lid are closed. The content theft deterrent (CTD) system will not arm without all of the doors and rear compartment lid being closed.

Perform the following to activate the CTD alarm mode:

Do all of the alarm mode functions activate (hazard lamps flash and horn pulses)?

Go to Testing for Intermittent Conditions and Poor Connections in Wiring Systems

Go to Step 3

Are only the hazard lamps inoperative?

Go to Step 4

Go to Content Theft Deterrent (CTD) Alarm Mode Inoperative

Place the hazard switch in the ON position.

Do the hazard lamps flash?

Go to Step 5

Go to Hazard Lamps Inoperative in Lighting Systems

Test the hazard switch signal circuit for an open. Refer to Circuit Testing and Wiring Repairs in Wiring Systems.

Did you find and correct the condition?

Go to Step 8

Go to Step 6

Inspect for poor connections at the harness connector of the dash integration module (DIM). Refer to Testing for Intermittent Conditions and Poor Connections and Connector Repairs in Wiring Systems.

Did you find and correct the condition?

Go to Step 8

Go to Step 7

1. Record the personalization settings to transfer to the new module. Refer to Personalization Description and Operation in Personalization.
2. Replace the DIM. Refer to Dash Integration Module Replacement in Body Control System.
3. Perform the dash integration module (DIM) set up procedure. Refer to Body Control Module (BCM) Programming/RPO Configuration on Body Control System.

Did you complete the replacement?

Go to Step 8

---

Operate the system to verify the repair.

Did you correct the condition?

System OK

Go to Step 2