Notice: Use care when handling the coolant sensor. Damage to the coolant sensor will affect the operation of the fuel control system.

1. Turn OFF the ignition
2. Drain the coolant to below the level of the engine coolant temperature (ECT) sensor. Refer to Cooling System Draining and Filling in Engine Cooling.
3. Disconnect the ECT sensor harness connector (1).
4. Remove the ECT sensor.

Notice: Use care when handling the coolant sensor. Damage to the coolant sensor will affect the operation of the fuel control system.

Notice: Replacement components must be the correct part number for the application. Components requiring the use of the thread locking compound, lubricants, corrosion inhibitors, or sealants are identified in the service procedure. Some replacement components may come with these coatings already applied. Do not use these coatings on components unless specified. These coatings can affect the final torque, which may affect the operation of the component. Use the correct torque specification when installing components in order to avoid damage.

1. Coat the sensor threads with sealer GM P/N 1050805, or equivalent.
2. Install the ECT sensor (1).

Tighten
Tighten the ECT sensor to 20 N·m (15 lb ft).

3. Connect the ECT sensor harness connector.
4. Refill the coolant system. Refer to Cooling System Draining and Filling .