Tools Required

J 24319-B Steering Linkage and Tie Rod Puller

1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
2. Remove the tire and wheel. Refer to Tire and Wheel Removal and Installation .



3. Remove the outer tie rod retaining nut (2).



4. Loosen the jam nut (2) on the inner tie rod (1).



5. Using J 24319-B remove the outer tie rod from the steering knuckle.



6. Remove the outer tie rod (3) from the inner tie rod (1).

1. Install the outer tie rod (3) to the inner tie rod (1).
2. Do not tighten the jam nut (2).



3. Install the outer tie rod (2) to the steering knuckle (1).




Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

4. Install the outer tie rod retaining nut (2).

Tighten

•	Tighten the outer tie rod retaining nut (2) to 47 N·m (35 lb ft).

•	Tighten the outer tie rod retaining nut (2) up to 1/6 additional turn, or 70 N·m (52 lb ft) maximum.

5. Install the tire and wheel. Refer to Tire and Wheel Removal and Installation .
6. Lower the vehicle.

Important: Ensure that the rack and pinion boot is not twisted or puckered during toe adjustment.

7. Adjust the front toe. Refer to Front Toe Adjustment .