Schematic Reference: Wiper/Washer Schematics

Connector End View Reference: Wiper/Washer Connector End Views

1

Did you review the Wiper/Washer System Description and Operation and perform the necessary inspections?

Go to Step 2

Go to Symptoms - Wiper/Washer Systems

Verify the fault is present.

Does the system operate normally?

Go to Testing for Intermittent Conditions and Poor Connections in Wiring Systems

Go to Step 3

While the windshield wiper/washer system is in the automatic mode does the wiper motor operate at continuous delay intervals?

Go to Step 5

Go to Step 4

1. Turn the ignition ON.
2. Operate the windshield wiper/washer switch from the OFF position through all of the delay positions.

Does the wiper motor cycle once and stop every time the switch is advanced to the next delay position?

Go to Step 11

Go to Wipers Inoperative - One or More Modes

1. Disconnect the moisture sensor connector.
2. Connect a test lamp from the accessory voltage supply circuit terminal in the harness connector to a good ground.

Does the test lamp illuminate?

Go to Step 6

Go to Step 9

Connect a test lamp from the accessory voltage supply circuit terminal to the ground circuit terminal in the moisture sensor harness connector.

Does the test lamp illuminate?

Go to Step 7

Go to Step 10

Test the moisture sensor signal 1 circuit for an open, short to ground, or short to voltage. Refer to Circuit Testing and Wiring Repairs in Wiring Systems.

Did you find and correct the condition?

Go to Step 13

Go to Step 8

Test the moisture sensor signal 2 circuit for an open, short to ground, or short to voltage. Refer to Circuit Testing and Wiring Repairs in Wiring Systems.

Did you find and correct the condition?

Go to Step 13

Go to Step 11

Repair the accessory voltage supply circuit to the moisture sensor for an open or high resistance. Refer to Circuit Testing and Wiring Repairs in Wiring Systems.

Is the repair complete?

Go to Step 13

--

Repair the moisture sensor ground circuit for an open or high resistance. Refer to Circuit Testing and Wiring Repairs in Wiring Systems.

Is the repair complete?

Go to Step 13

--

Inspect for poor connections at the moisture sensor. Refer to Testing for Intermittent Conditions and Poor Connections and Connector Repairs in Wiring Systems.

Did you find and correct the condition?

Go to Step 13

Go to Step 12

Replace the moisture sensor. Refer to Windshield Outside Moisture Sensor Replacement .

Is the repair complete?

Go to Step 13

--

Operate the system in order to verify the repair.

Did you correct the condition?

System OK

Go to Step 2