GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Cadillac 🢒 2003 🢒 DeVille 🢒 Body and Accessories 🢒 Entertainment 🢒 Communication Interface Module Replacement

Removal Procedure

    Object Number: 625727 Size: SH

    Important: The vehicle communication interface module (VCIM) has a specific set of unique numbers that tie the module to each vehicle. These numbers, the 10-digit station identification and the 11-digit electronic serial number, are used by the National Cellular Network and OnStar® to identify the specific vehicle. Because these numbers are tied to the vehicle identification number of the vehicle, you must never exchange these parts with those of another vehicle.

    Important: This vehicle may be equipped with one of two versions of the OnStar® System. Early production vehicles will have the generation 4 module. Later productions will have the generation 5 module. The two modules can not be interchanged. The generation 4 module can be identified by the use of three connector cavities. The generation 5 module uses four connector cavities.

  1. Remove the rear compartment trim. Refer to Rear Compartment Trim Panel Replacement .
  2. Remove the electrical component mounting bracket nuts (2).

    3. Notice: DO NOT completely remove the electrical component mounting bracket until the GPS antenna cable is removed from the cross car brace. Failure to do so may result in damage to the GPS connector.

  3. Carefully pull the electrical component mounting bracket (1) away from the body, so that the cross car brace is visible.

    4. Object Number: 820707 Size: SH
  4. Remove the GPS antenna cable (1) from the cross car brace.
  5. Place the electrical component mounting bracket (2) module side up in the rear compartment.

    6. Object Number: 787322 Size: SH
  6. Release the vehicle communication interface module (VCIM) (3) retaining tab (2).
  7. Slide the vehicle VCIM (3) out of the electrical component mounting bracket (1).
  8. Disconnect the antenna and electrical connections from the VCIM (3).

Installation Procedure

    Object Number: 787324 Size: SH
  1. When replacing the VCIM, record the 11-digit electronic serial number (ESN) and the 10-digit station identification (STID) number from the label on the new VCIM (1).
  2. Connect the antenna cable and electrical connections to the VCIM (1).
  3. Slide the VCIM (1) into the electrical component mounting bracket (3).
  4. Push in on the top of the VCIM (1) until an audible click is heard, indicating the retaining tab (2) has securely fastened the VCIM (1) to the electrical component mounting bracket (3).

    5. Object Number: 820709 Size: SH
  5. Partially install the electrical component mounting bracket (1) to the vehicle body.
  6. Attach the GPS antenna cable (1) to the cross car brace.

    7. Object Number: 625727 Size: SH
  7. Install the electrical component mounting bracket (1) to the studs.

    8. Notice: Refer to Fastener Notice in the Preface section.

  8. Install the electrical component mounting bracket nuts.

    9. Tighten
    Tighten the nuts (2) to 9 N·m (80 lb in).

  9. Install the rear compartment trim. Refer to Rear Compartment Trim Panel Replacement .

    10. Important: After replacing the vehicle communication interface module, you must reconfigure the OnStar® system. Failure to reconfigure the system will result in an additional customer visit for repair. In addition, pressing and holding the white dot button on the keypad will NOT reset this version of the OnStar® system. This action will cause a DTC to set.

  10. Reconfigure the OnStar® system. Refer to OnStar Reconfiguration .