Removal Procedure
- Remove
the fuel injector sight shield. Refer to
Fuel Injector Sight Shield Replacement
in Engine Mechanical.
- Remove the upper filler panel, if necessary, to gain access to the individual
coil being serviced. Refer to
Filler Panel Replacement - Upper
in Body Front End.
- Remove the ignition coil cover from the cam cover by lifting straight
up, if equipped.
- Disconnect the ignition coil wiring harness electrical connector from
the coil that needs to be replaced.
- Remove the ignition coil retaining bolt.
- Carefully remove the ignition coil assembly.
- If removal of all the coils are necessary, disconnect
the main coil wiring harness at the cam cover.
- Remove the coil assembly bolts and studs.
- Carefully remove the ignition coil assembly.
Installation Procedure
- Carefully install the ignition coil assembly.
Ensure that the spark plug seals are in position.
Notice: Refer to Fastener Notice in the Preface section.
- Install the ignition coil assembly retaining bolts and studs.
Tighten
Tighten the ignition coil assembly retaining bolts and studs to 10 N·m
(89 lb in).
- Connect the main coil wiring harness at the cam
cover.
Important: Ensure that the spark plug seals are in place when installing the ignition coil.
- Install the ignition coil.
- Install the ignition coil retaining bolt.
Tighten
Tighten the ignition coil retaining bolt to 10 N·m (89 lb in).
- Reconnect the ignition coil electrical connector.
- Install the ignition coil cover to the cam cover.
- Install the upper filler panel, if removed during disassembly. Refer to
Filler Panel Replacement - Upper
in Body Front End.
- Install the fuel injector sight shield. Refer to
Fuel Injector Sight Shield Replacement
in Engine Mechanical.