For 1990-2009 cars only
Tools Required
| • | J 45059 Angle Meter |
| • | J 44214 Flywheel Holder |
- Apply sealant, GM P/N 12346004, (Canadian P/N 10953480), or equivalent, to the engine flywheel bolts.
- Place the engine flywheel in position on the crankshaft.
- Loosely install a bolt at the top and bottom of the bolt circle allowing the engine flywheel to hang in position.
- Install the J 44214 to the engine block.
- Install the remaining engine flywheel bolts.
- Tighten the engine flywheel bolts.
Notice: Refer to Fastener Notice in the Preface section.
| 6.1. | First Pass |
Tighten
Tighten the engine flywheel retaining bolts to 15 N·m
(11 lb ft).
| 6.2. | Final Pass |
Tighten
Tighten the engine flywheel retaining bolts an additional
50 degrees using the J 45059
.
