GM Service Manual Online
For 1990-2009 cars only

Removal Procedure

  1. Remove the right side front engine mount. Refer to Engine Mount Replacement - Right Side .

  2. Object Number: 481563  Size: SH
  3. Disconnect the electrical connector (2) from the engine oil pressure switch (1).
  4. Important: Note positioning of the switch for correct installation.

  5. Remove the engine oil pressure switch (1) from the oil filter adapter (3).

Installation Procedure

    Notice: Refer to Fastener Notice in the Preface section.


    Object Number: 481563  Size: SH
  1. Install the engine oil pressure switch (1) to the oil filter adapter (3) in the same position as removed.
  2. Tighten
    Tighten the engine oil pressure switch to 16 N·m (12 lb ft).

  3. Connect the electrical connector (2) to the engine oil pressure switch (1).
  4. Install the right side front engine mount. Refer to Engine Mount Replacement - Right Side .
  5. Lower the vehicle.
  6. Adjust the engine oil level to the full mark.
  7. Inspect for oil leaks after engine start up.