Tools Required
J 39946
Crankshaft Socket - 4.0L and 4.6L
Removal Procedure
- Remove the engine front cover. Refer to
Engine Front Cover Replacement
.
- Align the primary timing marks (1)
using the
J 39946
.
- Install an engine front cover bolt (2) into the front of the engine.
Important: Securing the right secondary camshaft drive chain shoe will prevent the right camshaft drive sprocket teeth from skipping on the right secondary timing chain.
- Wrap mechanics wire (1) tightly around both the right secondary camshaft drive chain shoe (3) and the front cover bolt (2).
- Remove the 2 bolts attaching the right secondary camshaft drive chain tensioner to the engine block.
- Remove the right secondary camshaft drive chain tensioner, allowing the tensioner to expand as you remove it.
- Clean and inspect the camshaft timing drive components. Refer to
Camshaft Timing Drive Components Cleaning and Inspection
.
Installation Procedure
- Collapse the right secondary camshaft chain tensioner using the following procedure:
1.1. | Rotate the ratchet release lever (2) counterclockwise and hold. |
1.2. | Collapse the tensioner shoe (1) and hold. |
1.3. | Release the ratchet lever (2). |
- Slowly release the pressure on the shoe (1), until the ratchet lever (2) moves to the first detent and a "click" is heard and felt.
- Collapse the tensioner shoe (1) and hold.
- Insert a pin through the hole in the release lever in order to lock the tensioner shoe in the collapsed position.
Notice: Use the correct fastener in the correct location. Replacement fasteners
must be the correct part number for that application. Fasteners requiring
replacement or fasteners requiring the use of thread locking compound or sealant
are identified in the service procedure. Do not use paints, lubricants, or
corrosion inhibitors on fasteners or fastener joint surfaces unless specified.
These coatings affect fastener torque and joint clamping force and may damage
the fastener. Use the correct tightening sequence and specifications when
installing fasteners in order to avoid damage to parts and systems.
Important: Ensure the tensioner release lever is facing outward.
- Install the right secondary camshaft drive chain tensioner and retaining bolts.
Tighten
Tighten the secondary camshaft drive chain tensioner bolts to 25 N·m (18 lb ft).
- Remove the pin holding the tensioner to tighten any slack in the timing chain.
- Remove the mechanics wire (1) supporting the right secondary camshaft drive chain shoe (3).
- Remove the engine front cover bolt (2) from the front of the engine.
- Install the engine front cover. Refer to
Engine Front Cover Replacement
.