Caution: Refer to SIR Caution in the Preface section.

The lumbar massage module is hooked on the seat back frame cross brace and fastened to the seat belt shoulder strap adjuster tower with hook and loop material in order to hold the module in place.

1. Remove the seat back trim panel. Refer to Front Seat Back Trim Replacement.



2. Locate the massaging lumbar module (1) on the seat back frame, next to the shoulder belt adjuster tower, hooked to the seat back frame cross brace (3).
3. Release the hook and loop material (2) that retains the massaging lumbar module (1) to the seat back frame.
4. Push up on the massaging lumbar module (1) in order to un-hook the massaging lumbar module (1) from the seat back frame cross brace (3).



5. Remove the massaging lumbar module (1) from the seat back.
6. Disconnect the massage lumbar module (1) electrical connector.
7. Remove the massaging lumbar module (1).

1. Connect the electrical connector to the massaging lumbar module (1).
2. Install the massaging lumbar module (1) into the upper corner of the seat back next to the shoulder belt adjuster tower.



3. Hook the tab on the massaging lumbar module (1) to the seat back frame cross brace (3).
4. Secure the module (1) to the seat belt shoulder strap adjuster tower and seat back cross brace (3) with the hook and loop material (2).
5. Install the seat back trim panel. Refer to Front Seat Back Trim Replacement .
6. Refer to Control Module References for programming and setup information.