Removal Procedure
- Raise the vehicle. Refer to Lifting and Jacking the Vehicle .
- Disconnect the intake air filter from the body rail and the air hose.
- Slide the air compressor connector off of the connector anchor.
- Remove 3 bolts and the heat shield from the air compressor bracket.
- Remove the bolt attaching the air line and heat shield to the bracket.
- Disconnect the air hose from the air compressor assembly at 2 places.
Important: Before disconnecting the air hose from the intake air filter or the air compressor, clean the components and the surrounding area to prevent dirt and other foreign material from entering the air compressor.
Installation Procedure
- Connect the air hose to the air compressor assembly at 2 places.
- Connect the intake air filter to the air hose and the body rail.
- Install the heat shield and the harness tie with four bolts.
- Install the air compressor connector onto the connector anchor.
- Lower the vehicle. Refer to Lifting and Jacking the Vehicle .
Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.
Tighten
Tighten bolts to 4 N·m (35 lb in).
Important: Before driving the vehicle, turn the ignition on and wait approximately 45 seconds. This will permit the ALC system to execute the ARC system to execute the ARC, ensuring that the air adjustable shock absorbers are filled with residual pressure.
