For 1990-2009 cars only
- Remove the sunroof window. Refer to Sunroof Window Replacement .
- Fabricate a gage (2) out of a piece of paper. The width (A) of the gage is 46.8 mm (1.84 in).
- Set the gage into the track near the rear of the opening between the move driver slide (1) and the bracket.
- Move the driver slide fore or aft in order to get the proper setting.
- Repeat steps 3 and 4 for the other side.
- Install the sunroof window. Refer to Sunroof Window Replacement .
- Install the sunroof actuator motor.
- Operate the sunroof through all functions to ensure proper operation.
Important: If the power sunroof actuator motor is the only part being serviced, follow the power sunroof actuator motor replacement procedure for the sunroof actuator to sunroof window timing.
A new replacement power sunroof actuator motor is set to the fully closed and flush position at the factory.
