Removal Procedure
- Remove the standard mirror glass assembly (2)
from the housing (1) of the outside rear view mirror assembly.
| 1.1. | Manually tilt the mirror glass assembly inboard towards the vehicle. |
| 1.2. | Insert your fingers behind the mirror glass and gently pull the assembly
from the housing. |
- Disconnect the electrical connectors.
- If one or both of the actuator shaft(s) (4, 7) come off with the
mirror glass assembly perform the following procedure:
| 3.1. | Push the actuator in the direction of one of the two slots of the molded
ring where the actuator ball attaches and disengage it from the mirror glass assembly. |
| 3.2. | Ensure that the actuator springs (6) are not pushed down on the
actuator shafts but are seated in the groove provided. |
| 3.3. | Install the actuator shaft(s) (4, 7) on to the mirror assembly
power drive unit (5) by pressing and rotating the actuator on to the power
drive unit. |
| 3.4. | Ensure the actuator shafts are pushed down completely into the power drive
unit (5). |
| 3.5. | Push the memory plungers (3) into the power drive unit. (If
the vehicle is equipped with memory, RPO A45. |
Installation Procedure
- Rotate the actuator shafts (4, 7) on the
power drive unit in order to align the flats on the actuator ball with the corresponding
slots of the molded rings on the back of the mirror glass assembly.
- Connect the electrical connectors to the new standard mirror glass assembly (2).
- Install the new mirror glass assembly.
- Align the center pivot point and the actuator shaft(s) (4, 7) on
the mirror glass assembly with the corresponding attachment points on the power drive
unit.
- Use a 5 cm x 10 cm (2 in x 4 in)
sanding block and firmly press the mirror glass with enough force to engage the center
pivot point onto the power drive unit.
- Install the upper (vertical) actuator shaft (7), apply pressure
to the top of the mirror glass assembly with the sanding block until an audible snap
is heard.
- Install the vertical memory plunger (3) (if the vehicle
is equipped with memory, RPO A45).
- Manually tilt the glass assembly to the full down position.
- With the sanding block, apply pressure evenly to the bottom of the mirror
glass until an audible snap is heard.
- Install the side (horizontal) actuator (4).
- Manually tilt the glass assembly outboard, away from the vehicle.
- With the sanding block, apply pressure evenly to the outboard portion
of the mirror glass until an audible snap is heard.
- Install the horizontal memory plunger (3) (if equipped with
memory, RPO A45).
- Manually tilt the glass assembly inboard towards the vehicle.
- With the sanding block, apply pressure evenly to the inboard portion of
the mirror glass until an audible snap is heard.
- Check all functions by electrically operating the outside mirror assembly
in the following directions: (up, down, left and right).
- Perform a system check, if the outside mirror does not operate correctly.
Refer to
Diagnostic System Check - Vehicle
in Vehicle DTC Information .
- Ensure the actuator shafts are seated properly by repeating steps 6-13.
