GM Service Manual Online
For 1990-2009 cars only

Instrument Panel Compartment Replacement Base and DHS

Removal Procedure

  1. Remove the left knee bolster. Refer to Driver Knee Bolster Replacement .
  2. Remove the right knee bolster. Refer to Passenger Knee Bolster Replacement .

  3. Object Number: 474648  Size: SH
  4. Remove the four fasteners (2) retaining the center storage compartment (1).
  5. Disconnect the electrical connector if equipped.
  6. Remove the center compartment (1).

Installation Procedure

  1. Connect the electrical connector, if equipped.
  2. Install the center compartment (1).

  3. Object Number: 474648  Size: SH

    Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

  4. Install the four fasteners  (2) that retain the center storage compartment (1).
  5. Tighten
    Tighten the fasteners (2) to 9 N·m (80 lb in).

  6. Install the left knee bolster. Refer to Driver Knee Bolster Replacement .
  7. Install the right knee bolster. Refer to Passenger Knee Bolster Replacement .

Instrument Panel Compartment Replacement DTS

Removal Procedure

  1. Remove the console trim plate. Refer to Front Floor Console Trim Plate Replacement .

  2. Object Number: 474660  Size: SH
  3. Remove the 2 fasteners (2) at the bottom of the compartment.
  4. Open the compartment (1) door.
  5. Grasp the inside of the IP compartment (1).
  6. Pull out on the compartment (1) in order to release the upper retainers.

  7. Disconnect the electrical connector (3).
  8. Remove the IP compartment (1).

Installation Procedure


    Object Number: 474660  Size: SH
  1. Partially install the compartment (1).
  2. Connect the electrical connector (3).
  3. Align the upper retainers with the IP and push on the top of the compartment in order to engage the upper retainers.
  4. Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

  5. Install the bottom compartment (1) fasteners (2).
  6. Tighten
    Tighten the fasteners (2) to 2 N·m (18 lb in).

  7. Install the console trim plate. Refer to Front Floor Console Trim Plate Replacement .