GM Service Manual Online
For 1990-2009 cars only

Circuit Description

The dash integration module (DIM) has a designated circuit for monitoring vehicle system voltage. Also, other modules monitor system voltage. The DIM sends the system voltage status to other modules that do not monitor system voltage via class 2 message. When the DIM sets B1390, the system voltage status sent to the modules will default to 12.9 volts.

DTC Descriptor

This diagnostic procedure supports the following DTC:

DTC B1328 Device Power Circuit High

Conditions for Running the DTC

This DTC shall run only if the DIM has power, ground and the ignition is not in START mode. This DTC shall execute regardless of the battery voltage, except when the DTC B1390 is set current.

Conditions for Setting the DTC

This DTC will set as current when the voltage is greater than 15.9 volts for 1.2 seconds and DTC B1390 is not set current in the DIM.

Action Taken When the DTC Sets

    • A message shall be sent out on the class 2 lines to notify all other modules of low battery voltage.
    • The modules disable the setting of U codes and other DTCs.

Conditions for Clearing the DTC

    • The DTC will clear current status when the voltage is less than 15.5 volts for 1.2 seconds.
    • A history DTC will clear after 50 consecutive ignition cycles if the condition for the malfunction is no longer present.
    • Use the ON-Board clearing DTCs feature.
    • Use a scan tool.

Diagnostic Aids

Using a battery charger to jumpstart the vehicle may set DTC B1328 as a history code.

Test Description

The numbers below refer to the step numbers on the diagnostic table.

  1. Tests for the proper voltage at the DIM. If the voltage is not within the proper operating range, the charging system needs to be checked.

  2. Tests for the proper voltage at the module setting the DTC B1328. If the voltage is not within the proper operating range, the charging system needs to be checked

Step

Action

Yes

No

1

Did you perform the Diagnostic System Check - Vehicle?

Go to Step 2

Go to Diagnostic System Check - Vehicle in Vehicle DTC Information

2

  1. Install a scan tool.
  2. Turn ON the ignition, with the engine OFF.
  3. With a scan tool, monitor the DTC Information for DTC B1328 in the dash integration module (DIM).

Does the scan tool indicate that DTC B1328 is current?

Go to Step 4

Go to Step 3

3

With a scan tool, monitor the DTC Information for DTC B1328 in the affected module.

Does the scan tool indicate that DTC B1328 is current?

Go to Step 4

Go to Diagnostic Aids

4

Replace the module setting the code. Refer to Control Module References in Computer/Integrating Systems for replacement, setup, and programming.

Did you complete the replacement?

Go to Step 5

--

5

  1. Use the scan tool in order to clear the DTCs.
  2. Operate the vehicle within the Conditions for Running the DTC as specified in the supporting text.

Does the DTC reset?

Go to Step 2

System OK