GM Service Manual Online
For 1990-2009 cars only

Circuit Description

The steering column module determines the telescoping position of the steering column based on the following factors:

    • Inputs received from the telescope position sensor that is built into the telescope actuator
    • The telescoping actuator

The steering column module supplies a 5-volt reference and a ground to the telescoping position sensor, while also monitoring the column position from the telescope position signal circuit.

DTC Descriptor

This diagnostic procedure supports the following DTC:

DTC B2862 Telescope Position Sensor Low

Conditions for Running the DTC

DTC B1327 is not set as current.

Conditions for Setting the DTC

This DTC sets as current when the voltage at the steering column telescope motor signal is less than 0.12 volts for 2 seconds on the telescoping circuit.

Action Taken When the DTC Sets

The steering column module will not allow the affected motor to work during memory recall or easy exit operations. However, the motor will still operate during manual switch positioning.

Conditions for Clearing the DTC

This DTC will clear from current status when the voltage is greater than 0.12 volts for 2 seconds.

Step

Action

Value(s)

Yes

No

Schematic Reference: Tilt/Telescoping Steering Column Schematics

Connector End View Reference: Steering Wheel and Column Connector End Views

1

Did you perform the Diagnostic System Check - Vehicle?

--

Go to Step 2

Go to Diagnostic System Check - Vehicle in Vehicle DTC Information

2

  1. Turn ON the ignition, with the engine OFF.
  2. In order to measure the voltage at the steering column telescope motor signal circuit, backprobe the steering column telescope motor signal circuit using a DMM.

Is the voltage greater than the specified parameter?

0.12 V

Go to Step 8

Go to Step 3

3

  1. Turn OFF the ignition.
  2. Disconnect the telescope actuator harness connector from the tilt/telescoping steering column module.
  3. Turn ON the ignition, with the engine OFF.
  4. Probe the steering column telescope motor signal circuit on the module with a DMM that is connected to a good ground.

Does the DMM indicate the voltage is greater than the specified value?

4.8 V

Go to Step 4

Go to Step 6

4

Inspect for poor connections at the harness connector of the telescope actuator. Refer to Testing for Intermittent Conditions and Poor Connections and Connector Repairs in Wiring Systems.

Did you find and correct the condition?

--

Go to Step 7

Go to Step 5

5

Replace the telescope actuator. Refer to Telescope Actuator Assembly Replacement .

Did you complete the replacement?

--

Go to Step 7

--

6

Important:: Perform the set up procedure for the steering column module.

Replace the steering column module. Refer to Steering Column Control Module Replacement .

Did you complete the replacement?

--

Go to Step 7

--

7

Perform the Steering Column Control Module Programming. Refer to Steering Column Control Module Programming .

Did you complete the action?

--

Go to Step 8

--

8

  1. Clear the DTCs with a scan tool.
  2. Operate the vehicle within the Conditions for Running the DTC, as specified in the supporting text.

Does DTC B2862 reset?

--

Go to Step 2

System OK