The steering column module determines the tilt position of the steering column based on the following factors:
• | Inputs received from the tilt position sensor that is built into the telescope actuator |
• | The telescoping actuator |
The steering column module supplies a 5-volt reference and ground to the tilt position sensor, while also monitoring the column position from the telescope position signal circuit.
This diagnostic procedure supports the following DTC:
DTC B2882 Tilt Position Sensor Low
DTC B1327 is not set as current.
The DTC sets as current when the voltage at the steering column tilt motor signal is less than 4.8 volts for 2 seconds on the tilt circuit.
The steering column module will not allow the affected motor to work during memory recall and/or easy exit operations. However, the motor will still operate for manual switch positioning.
This DTC will clear from current status when the voltage is greater than 0.12 volts for 2 seconds.
Step | Action | Value(s) | Yes | No |
---|---|---|---|---|
Schematic Reference: Tilt/Telescoping Steering Column Schematics Connector End View Reference: Steering Wheel and Column Connector End Views | ||||
1 | Did you perform the Diagnostic System Check - Vehicle? | -- | Go to Step 2 | Go to Diagnostic System Check - Vehicle in Vehicle DTC Information |
2 |
Is the voltage greater than the specified parameter? | 0.12 V | Go to Step 8 | Go to Step 3 |
3 |
Does the DMM indicate the voltage is greater than the specified value? | 4.8 V | Go to Step 4 | Go to Step 6 |
4 | Inspect for poor connections at the harness connector of the tilt actuator. Refer to Testing for Intermittent Conditions and Poor Connections and Connector Repairs in Wiring Systems. Did you find and correct the condition? | -- | Go to Step 7 | Go to Step 5 |
5 | Replace the tilt actuator. Refer to Tilt Actuator Assembly Replacement . Did you complete the replacement? | -- | Go to Step 7 | -- |
6 |
Important:: Perform the set up procedure for the steering column module. Replace the steering column module. Refer to Steering Column Control Module Replacement . Did you complete the replacement? | -- | Go to Step 7 | -- |
7 | Perform the Steering Column Control Module Programming. Refer to Steering Column Control Module Programming . Did you complete the action? | -- | Go to Step 8 | -- |
8 |
Does DTC B2882 reset? | -- | Go to Step 2 | System OK |