GM Service Manual Online
For 1990-2009 cars only

Tools Required

J 26889 Accumulator Piston Compressor

Caution: Refer to Brake Fluid Irritant Caution in the Preface section.

Notice: Refer to Brake Fluid Effects on Paint and Electrical Components Notice in the Preface section.

Removal Procedure

Caution: The accumulator contains compressed gas. Always use the proper tools and follow the recommended procedures or personal injury may result. Do not apply heat to accumulator. Do not attempt to repair an inoperative accumulator. Always replace an inoperative accumulator with a new one. Dispose of an inoperative accumulator by drilling a 1.5 mm (1/16 in) diameter hole through the end of the accumulator can, opposite the O-ring.

Caution: Push rod removal is not recommended. Improper staking of the push rod to the Hydroboost reaction piston can result in a loss of brakes. If the rod or seals require service, the entire unit must be replaced.

  1. Press brake pedal at least ten times to relieve pressure in the accumulator.

  2. Object Number: 360977  Size: SH
  3. Remove the master cylinder from the hydraulic brake booster. Refer to Master Cylinder Replacement .

  4. Object Number: 791940  Size: SH
  5. Place the J 26889 over the end of the accumulator.
  6. Install the nut on the stud.
  7. Press the accumulator with a C-clamp. If accumulator does not move with moderate pressure, remove the C-clamp and press brake pedal 10 times to relieve pressure in the accumulator.

  8. Object Number: 360991  Size: SH
  9. Rotate retaining ring (2) until either end of the ring is under the access hole (1).
  10. Press and hold the retaining ring (2) with a small tool inserted into the access hole (1).

  11. Object Number: 361385  Size: SH
  12. Remove the accumulator retainer ring (1) using a small hook shaped tool.

  13. Object Number: 791940  Size: SH
  14. Release the C-clamp.
  15. Remove the nut from the stud.
  16. Remove the J 26889 .

  17. Object Number: 361385  Size: SH
  18. Remove the accumulator (2) and O-ring seal (3).

Installation Procedure


    Object Number: 361385  Size: SH
  1. Lubricate all seals and metal friction points with power steering fluid.
  2. Install the accumulator (2) and O-ring seal (3).

  3. Object Number: 791940  Size: SH
  4. Place the J 26889 over the end of the accumulator.
  5. Install the nut on the stud.
  6. Press the accumulator with a C-clamp.

  7. Object Number: 360991  Size: SH
  8. Install the accumulator retainer ring (1).

  9. Object Number: 791940  Size: SH
  10. Release the C-clamp.
  11. Remove the nut from the stud.
  12. Remove the J 26889 .

  13. Object Number: 360977  Size: SH
  14. Install the master cylinder to the hydraulic booster. Refer to Master Cylinder Replacement .