For 1990-2009 cars only
Removal Procedure
- Remove the console trim plate. Refer to Front Floor Console Trim Plate Replacement in Instrument Panel, Gages and Console.
- Unsnap the shift cable terminal from the shifter pin.
- Disconnect the automatic transmission shift lock actuator solenoid wire harness connector.
- Remove the shifter fasteners.
- Remove the shifter assembly.
Installation Procedure
- Install the shifter assembly.
- Install the shifter fasteners.
- Insert the shift cable onto the shifter control.
- Connect the automatic transmission shift lock solenoid wire harness connector.
- Adjust the shift cable as follows.
- Install the console trim plate (1). Refer to Front Floor Console Trim Plate Replacement in Instrument Panel, Gages and Console.
Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.
Tighten
Tighten the shifter fasteners to 9 N·m (79 lb in).
| 5.1. | Place the shifter into the N (neutral) position. |
| 5.2. | Loosen the shifter adjuster nut. |
| 5.3. | Tighten the adjuster nut. |
Tighten
Tighten the adjuster nut to 25 N·m (18 lb ft).
