Remove the nine 10 mm bolts (534) from the oil transfer
plate (956) and wire harness assembly (943).
Remove the oil transfer plate (956).
Disconnect the wire harness extension (943) from the wire harness
assembly (12).
Important: Do not reuse retainer (915), it must be replaced.
Use a small screwdriver in order to disconnect the manual valve link
retainer (915) from the manual valve link (913).
Important: Do not pry against the internal mode switch assembly.
Lift the manual valve and link assembly link (916) out of the
inside detent lever (17).
Remove the two 10 mm
nuts (955) and the fourteen 10 mm bolts (958) from the
lower control valve body assembly (903).
Lift the lower channel plate, control valve body and accumulator
assembly (903) and the lower control valve body wire harness extension (943)
from the case as a single unit.