GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Cadillac 🢒 2005 🢒 DeVille 🢒 Steering 🢒 Steering Wheel and Column 🢒 Transmission Control Replacement

Removal Procedure

    Object Number: 105570 Size: SH
  1. Remove the console trim plate. Refer to Front Floor Console Trim Plate Replacement in Instrument Panel, Gages and Console.

    2. Object Number: 291754 Size: SH
  2. Unsnap the shift cable terminal from the shifter pin.
  3. Disconnect the automatic transmission shift lock actuator solenoid wire harness connector.

    4. Object Number: 291888 Size: SH
  4. Remove the shifter fasteners.
  5. Remove the shifter assembly.

Installation Procedure

    Object Number: 291888 Size: SH
  1. Install the shifter assembly.

    2. Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

  2. Install the shifter fasteners.

    3. Tighten
    Tighten the shifter fasteners to 9 N·m (79 lb in).


    Object Number: 291754 Size: SH
  3. Insert the shift cable onto the shifter control.
  4. Connect the automatic transmission shift lock solenoid wire harness connector.
  5. Adjust the shift cable as follows.
    6. 5.1. Place the shifter into the N (neutral) position.
    5.2. Loosen the shifter adjuster nut.
    5.3. Tighten the adjuster nut.

    Tighten
    Tighten the adjuster nut to 25 N·m (18 lb ft).


    Object Number: 105570 Size: SH
  6. Install the console trim plate (1). Refer to Front Floor Console Trim Plate Replacement in Instrument Panel, Gages and Console.