Tools Required

Caution: Refer to SIR Caution in the Preface section.




1. Disable the SIR system. Refer to SIR Disabling and Enabling in SIR.
2. Remove the inflatable restraint steering wheel module. Refer to Inflatable Restraint Steering Wheel Module Replacement in SIR.



3. Disconnect the steering wheel electrical connector.
4. Remove the steering wheel retaining nut.
5. Install J 42578 (2) and J 1859-A (1) to the steering wheel.
6. Using J 42578 (2) and J 1859-A (1) remove the steering wheel .
7. Remove the J 42578 (2) and J 1859-A (1) from the steering wheel.

1. Route the wiring through the steering wheel.
2. Align the splines on the steering wheel with the splines on the shaft.
3. Install the steering wheel to the upper shaft.

Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

4. Install the steering wheel retaining nut.

Tighten
Tighten the nut to 41 N·m (30 lb ft).

5. Connect the steering wheel electrical connector.
6. Install the inflatable restraint steering wheel module. Refer to Inflatable Restraint Steering Wheel Module Replacement in SIR.
7. Enable the SIR system. Refer to SIR Disabling and Enabling in SIR.