GM Service Manual Online
For 1990-2009 cars only

Circuit Description

The steering column module receives ground inputs from contacts inside the tilt/telescoping switch. The steering column module then supplies battery voltage to the tilt motor up or down circuit, or the telescope motor in or out circuit depending on which direction of movement is requested. Both motors are reversible and the circuits are simply reversed to accomplish movement in opposite directions.

DTC Descriptors

This diagnostic procedure supports the following DTCs:

    • DTC 2853 Telescope Forward Switch Circuit High
    • DTC 2858 Telescope Rearward Switch Circuit High
    • DTC 2873 Tilt Up Switch Circuit High
    • DTC 2878 Tilt Down Switch Circuit High

Conditions for Running the DTC

The steering column module is ON.

Conditions for Setting the DTC

The steering column module detects a switch input for more than 30 consecutive seconds after movement of the motor in the requested direction has stopped.

Action Taken When the DTC Sets

    • The motor that is being driven by the failed switch will be deactivated.
    • Memory recall functions will be disabled.

Conditions for Clearing the DTC

    • A current DTC will clear when the failed switch input is no longer active.
    • A history DTC will clear after 100 ignition cycles.

Diagnostic Aids

An intermittently stuck switch can cause this DTC to set. Refer to Testing for Intermittent Conditions and Poor Connections in Wiring Systems.

Step

Action

Yes

No

Schematic Reference: Tilt/Telescoping Steering Column Schematics

Connector End View Reference: Steering Wheel and Column Connector End Views

1

Did you perform the Diagnostic System Check - Vehicle?

Go to Step 2

Go to Diagnostic System Check - Vehicle in Vehicle DTC Information

2

  1. Turn ON the ignition, with the engine OFF.
  2. Retrieve DTCs with a scan tool.

Is DTC B2853, B2858, B2873, or B2878 displayed as current?

Go to Step 3

Go to Diagnostic Aids

3

  1. Turn OFF the ignition.
  2. Disconnect the tilt/telescoping switch harness connector.
  3. Turn ON the ignition, with the engine OFF.
  4. Retrieve DTCs with the scan tool.

Is DTC B2853, B2858, B2873, or B2878 displayed as current?

Go to Step 4

Go to Step 5

4

Inspect for poor connections at the harness connector of the tilt/telescoping steering column switch.

Refer to Testing for Intermittent Conditions and Poor Connections in Wiring Systems.

Did you find and correct the condition?

Go to Step 7

Go to Step 6

5

Replace the tilt/telescoping steering column switch. Refer to Telescope Actuator Switch Replacement .

Did you complete the replacement?

Go to Step 7

--

6

Important:: Perform the set up procedure for the steering column module.

Replace the steering column module. Refer to Steering Column Control Module Replacement .

Did you complete the replacement?

Go to Step 7

--

7

Perform the Steering Column Control Module Programming. Refer to Steering Column Control Module Programming .

Did you complete the action?

Go to Step 8

--

8

  1. Clear the DTCs with the scan tool.
  2. Operate the vehicle within the Conditions for Running the DTC as specified in the supporting text.

Does the DTC reset?

Go to Step 2

System OK