Removal Procedure
Caution: Refer to SIR Caution in the Preface section.
- Remove the IP (Instrument Panel) upper trim pad. Refer to
Instrument Panel Upper Trim Pad Replacement
.
- Remove the IP cluster trim panel. Refer to
Instrument Cluster Trim Panel Replacement
.
- Remove the IP storage compartment. Refer to
Instrument Panel Storage Compartment Replacement
.
- Remove the screws securing the right IP accessory trim panel (1)
to the IP.
- Partially remove the trim
panel (1) in order to disconnect the hazard switch electrical connector.
- Remove the right accessory trim panel (1).
Installation Procedure
- Connect the electrical connector to the hazard switch.
- Install the right accessory
trim panel (1).
Notice: Use the correct fastener in the correct location. Replacement fasteners
must be the correct part number for that application. Fasteners requiring
replacement or fasteners requiring the use of thread locking compound or sealant
are identified in the service procedure. Do not use paints, lubricants, or
corrosion inhibitors on fasteners or fastener joint surfaces unless specified.
These coatings affect fastener torque and joint clamping force and may damage
the fastener. Use the correct tightening sequence and specifications when
installing fasteners in order to avoid damage to parts and systems.
- Install the trim panel screws.
Tighten
Tighten the screws to 2 N·m (18 lb in).
- Install the IP cluster trim panel. Refer to
Instrument Cluster Trim Panel Replacement
.
- Install the IP storage compartment. Refer to
Instrument Panel Storage Compartment Replacement
.
- Install the IP upper trim pad. Refer to
Instrument Panel Upper Trim Pad Replacement
.