Tools Required

1. Remove the transaxle assembly. Refer to Transmission Replacement in Automatic Transaxle - 4T80-E.
2. Install the J 44214 to the engine block.



3. Loosen the 8 engine flywheel mounting bolts.
4. Remove 7 of the 8 flywheel bolts leaving 1 bolt at the top of the crankshaft rotation.
5. Grip the engine flywheel and remove the remaining bolt. Do not drop the engine flywheel when removing the final bolt.
6. Clean and inspect the engine flywheel. Refer to Engine Flywheel Cleaning and Inspection .

1. Apply sealant, GM P/N 12346004 ( Canadian P/N 10953480) or equivalent, to the flywheel mounting bolts.



2. Place the engine flywheel in position on the crankshaft.

Notice: Refer to Fastener Notice in the Preface section.

3. Install the mounting bolts.

3.1.	First Pass

Tighten
Tighten the flywheel mounting bolts to 15 N·m (11 lb ft).

3.2.	Final Pass

Tighten the flywheel mounting bolts an additional 50 degrees using the J 45059 .

4. Remove the J 44214 from the engine block.
5. Install the transaxle assembly. Refer to Transmission Replacement in Automatic Transaxle - 4T80-E.