The rear fuse block is located under the rear seat on the driver's side. The rear seat cushion must be removed to access the rear fuse block.
Removing the Rear Seat Cushion
Notice: If you touch the exposed wires with the metal on the seat cushion, you could cause a short that could damage the battery and or wires. Avoid contact between the rear seat and the fuse center whenever you remove or reinstall the rear seat. Do not remove covers from any of the covered parts, and do not store anything under the seats.
To remove the rear seat cushion, do the following:
- Pull up on the front of the cushion to release the front hooks.
- Pull the cushion up and out toward the front of the vehicle.
To access the fuse block, push in the two tabs located at each end of the fuse block cover. Then lift the cover off.
To reinstall the rear seat cushion, do the following:
Caution: A safety belt that is not properly routed through the seat cushion or is twisted will not provide the protection needed in a crash. If the safety belt has not been routed through the seat cushion at all, it will not be there to work for the next passenger. The person sitting in that position could be badly injured. After reinstalling the seat cushion, always check to be sure that the safety belts are properly routed and are not twisted.
- Buckle the center passenger position safety belt, then route the safety belts through the proper slots in the seat cushion. Do not let the safety belts get twisted.
- Slide the rear of the cushion up and under the seatback so the rear-locating guides hook into the wire loops on the back frame.
- With the seat cushion lowered, push rearward and then press down on the seat cushion until the spring locks on both ends engage.
- Check to make sure the safety belts are properly routed and that no portion of any safety belt is trapped under the seat. Also make sure the seat cushion is secured.
Fuses | Usage |
|---|---|
1 | Fuel Pump |
2 | Heater, Ventilation and Air Conditioning Battery |
3 | Memory Seat, Tilt and Telescoping Steering |
4 | RR Lumbar, Antenna |
5 | Driver Door Module |
6 | Heated Seat Left Rear |
7 | Power Tilt and Telescoping Steering |
8 | Supplemental Inflation Restraint |
9 | SDAR (XM™ Satellite Radio) |
10 | Lamps Park Right |
11 | Fuel Tank Ventilation Solenoid |
12 | Ignition 1 |
13 | Interior Lamp Dimmer Module |
14 | Sunshade |
15 | Navigation |
16 | Heated Seat Left Front |
17 | Interior Lamps |
18 | Right Rear Door Module |
19 | Stoplamps |
20 | Park/Reverse |
21 | Audio |
22 | Retained Accessory Power for Sunroof |
23 | Lamps, Parking Left |
24 | Night Vision |
25 | Passenger Door Module |
26 | Body |
27 | Export Lights, Power Locks |
28 | Rear HVAC Blower |
29 | Ignition Switch |
30 | Turn Signal, Hazard Signal |
31 | Reverse, Locks |
32 | Continuous Variable Road Sensing Suspension |
33 | Heating, Ventilation, Air Conditioning |
34 | Ignition 3 Rear |
35 | Antilock Braking System |
36 | Heated Seat, Right Front |
37 | Heated Seat, Right Rear |
38 | Dimmer |
60 | Not Used |
61 | Rear Defog |
62 | HVAC Blower |
63 | Audio Amplifier |
64 | Automatic Level Control Compressor, Exhaust |
65 | Not Used |
66 | Not Used |
67 | Not Used |
68 | Not Used |
69 | Not Used |
70 | Not Used |
71 | Not Used |
72 | Not Used |
73 | Not Used |
74 | Not Used |
75 | Not Used |
Relays | Usage |
|---|---|
39 | Fuel Pump |
40 | Parking Lamps |
41 | Ignition 1 |
42 | Not Used |
43 | Not Used |
44 | Park Shift Interlock |
45 | Reverse Lamps |
46 | Retained Accessory Power for Sunroof |
47 | Reverse Lockout |
48 | Suspension Dampers |
49 | Ignition 3 |
50 | Fuel Tank Door Release |
51 | Interior Lamps |
52 | Trunk Release |
53 | Not Used |
54 | Lock, Cylinder |
55 | Automatic Level Control Compressor |
58 | Not Used |
59 | Rear Defog |
Circuit Breakers | Usage |
|---|---|
56 | Power Seats |
57 | Power Windows |
The spare fuses and fuse puller are located in the underhood fuse block. See Underhood Fuse Block .
