GLOVEBOX DOOR HARD TO CLOSE RELOCATE DOOR HINGE

VEHICLES AFFECTED: 1986 ELDORADOS AND SEVILLES

Some 1986 Eldorado and Seville instrument panel compartment doors may be difficult to close. This condition may be corrected by lowering the door hinge as instructed below.

Remove glove box door and hinge. Refer to Figure 1.

1. Remove four glove box module screws.

2. Remove glove box module.

3. Remove four glove box door mouriting screws.

4. Disconnec lamp connectors.

5. Unclip harness from hinge assembly.

6. Remove four outer screws and reinforcement (item 4).

7. Remove two mounting screws and hinge assembly (item 3).

8. Notice two locating studs (2) one on each side of hinge assembly.

9. File the bottom of the locating stud slots as necessary to sufficiently lower the hinge assembly. (Figure , item 1).

Reassemble glove box door and hinge.

10. Align hinge assembly in lower position.

11. Reinstall two mounting screws.

12. Reinstall reinforcement.

13. Reinstall four outer hinge screws.

14. Secure harness in hinge assembly clip.

15. Connect lamp connectors.

16. Align door to hinge assembly.

17. Reinstall four glove box door mounting screws.

18. Reinstall glove box module.

19. Reinstall four glove box module screws.

General Motors bulletins are intended for use by professional technicians, not a "do-it-yourselfer". They are written to inform those technicians of conditions that may occur on some vehicles, or to provide information that could assist in the proper service of a vehicle. Properly trained technicians have the equipment, tools, safety instructions and know-how to do a job properly and safely. If a condition is described, do not assume that the bulletin applies to your vehicle, or that your vehicle will have that condition. See a General Motors dealer servicing your brand of General Motors vehicle for information on whether your vehicle may benefit from the information.