GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Cadillac 🢒 2001 🢒 Eldorado 🢒 Engine 🢒 Engine Electrical 🢒 Battery Positive Cable Replacement

Removal Procedure
    • Always use replacement cables that are of the same type, diameter and length of the cables that you are replacing.
    • Always route the replacement cable the same way as the original cable.
  1. Disconnect the battery negative cable. Refer to Battery Negative Cable Disconnection and Connection .
  2. Remove the intake manifold. Refer to Intake Manifold Replacement in Engine Mechanical-4.6L.
  3. Disconnect the battery positive cable from the starter.

    4. Object Number: 640486 Size: SH
  4. Disconnect the battery positive cable from the battery.

    5. Object Number: 640489 Size: SH
  5. Remove the bolt attaching the cable harness retainer to the body rail.

    6. Object Number: 640487 Size: SH
  6. Disconnect the cable harness clip (5) from the camshaft cover.
  7. Remove the engine splash shield. Refer to Engine Splash Shield Replacement in Body Front End.
  8. Remove the generator output BAT terminal nut and disconnect the battery positive lead (4) from the generator.
  9. Remove the bolts (3) attaching the cable harness clips to the engine frame.
  10. Disconnect the positive battery cable (1) from the underhood fuse block.
  11. Remove the battery positive cable from the vehicle.

Installation Procedure

    Object Number: 640487 Size: SH

    Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

  1. Place the positive battery cable into the cable harness clips along the engine frame.

    2. Tighten
    Tighten the cable harness clip retaining bolts (3) to 6 N·m (53 lb in).

  2. Connect the battery positive cable (1) to the underhood fuse block.

    3. Tighten
    Tighten the battery positive cable to underhood fuse block nut to 11 N·m (97 lb in).

  3. Connect the battery positive lead (4) and install the generator output BAT terminal nut.

    4. Tighten
    Tighten the generator output BAT terminal nut to 12.5 N·m (111 lb in).

  4. Install the engine splash shield. Refer to Engine Splash Shield Replacement in Body Front End.
  5. Connect the cable harness clip (5) to the camshaft cover.

    6. Object Number: 640489 Size: SH
  6. Install the bolt attaching the cable harness retainer to the body rail.

    7. Tighten
    Tighten the cable harness retainer bolt to 6 N·m (53 lb in).


    Object Number: 640486 Size: SH
  7. Connect the battery positive cable to the battery.

    8. Tighten
    Tighten the battery cable to 17 N·m (13 lb ft).

  8. Connect the battery positive cable to the starter.

    9. Tighten
    Tighten the battery positive cable to starter terminal nut to 10 N·m (89 lb ft).

  9. Install the intake manifold. Refer to Intake Manifold Replacement in Engine Mechanical-4.6L.
  10. Connect the battery negative cable. Refer to Battery Negative Cable Disconnection and Connection .