Tools Required

J 39400-A Halogen Leak Detector

1. Recover the refrigerant. Refer to Refrigerant Recovery and Recharging .



2. Remove the accumulator inlet and outlet fittings.
3. Remove the accumulator retention bolts.



4. Remove the accumulator from the mounting bracket.
5. Remove the insulator cover from the accumulator.

1. Install the insulator cover to the accumulator.



2. Install the accumulator to the mounting bracket.

Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

3. Install the accumulator retention bolts.

Tighten
Tighten the bolts to 4 N·m (35 lb in).

4. Install new dual O-rings.



5. Install the inlet and outlet refrigerant lines to the accumulator.

Tighten
Tighten the dual O-ring fittings at the accumulator to 24 N·m (18 lb ft).

6. Recharge the A/C system. Refer to Refrigerant Recovery and Recharging .
7. Leak test the fittings of the component using the J 39400-A .