- Remove the lock housing assembly. Refer to
Lock Housing Assembly - Disassemble - Off Vehicle
.
- Remove the switch actuator
pivot pin (2) from the windshield wiper and washer switch assembly (1).
- If removal of the windshield wiper and washer switch assembly (1)
is not needed let the windshield wiper and washer switch assembly (1)
hang freely.
- Remove the windshield wiper and washer switch assembly (1)
from the lock housing cover and sleeve assembly following these steps:
4.1. | Remove the wire protector shield. |
4.2. | Remove the windshield wiper and washer switch assembly connector
from the bulk head connector. |
| Important: Use care not to damage the wires when pulling the windshield wiper and
washer switch assembly wire harness through the steering column.
|
4.3. | Pull the wire harness through the steering column. |