Removal Procedure
- Disable the SIR system. Refer to Disabling the SIR System in SIR.
- Remove the steering column. Refer to Steering Column Replacement .
- Disconnect the dimmer switch electrical connector.
- Remove the dimmer switch retaining nut (4) and bolt (3).
- Remove the dimmer switch rod (5) from the dimmer switch.
- Remove the dimmer switch (2).
Caution: This vehicle is equipped with a Supplemental Inflatable Restraint (SIR) System. Failure to follow the correct procedure could cause the following conditions:
• Air bag deployment • Personal injury • Unnecessary SIR system repairs • Refer to SIR Component Views in order to determine if you are performing service on or near the SIR components or the SIR wiring. • If you are performing service on or near the SIR components or the SIR wiring, disable the SIR system. Refer to Disabling the SIR System.
Installation Procedure
- Install the dimmer switch (2).
- Install the dimmer switch rod (5) to the dimmer switch (2).
- Install the dimmer switch retaining nut (4) and bolt (3).
- Connect the dimmer switch electrical connector.
- Install the steering column. Refer to Steering Column Replacement .
- Enable the SIR system. Refer to Enabling the SIR System in SIR.
Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.
Tighten
Tighten the dimmer switch retaining nut and bolt to 4 N·m
(35 lb in).
