- If installing a NEW starter transfer the cables from the old starter.
- Install the positive battery cable to the starter motor stud.
- Install the starter motor stud nut.
- Install the solenoid wiring harness to the starter solenoid stud.
- Install the starter solenoid stud nut.
- Place the starter motor in position in the engine valley.
- Install the two starter motor retaining bolts.
- Install the knock sensor (1).
- Connect the knock sensor wire lead.
Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.
Tighten
Tighten the starter motor stud nut to 9.5 N·m (84 lb in).
Tighten
Tighten the starter solenoid stud nut to 3.4 N·m (30 lb in).
Tighten
Tighten the starter motor retaining bolts to 30 N·m (22 lb ft).
Tighten
Tighten the knock sensor (1) to 20 N·m (15 lb ft).
