Remote CD Changer Replacement U1S

1. Open the rear compartment lid.
2. Remove the 2 bolts (1) from the floor bracket at the front of the (CD) changer.
3. Slide the (CD) changer (3) forward in order to release the changer from the floor pan.
4. Disconnect the electrical connector (2) from the compact disc (CD) changer (3).



5. Remove the (CD) changer (3) from the mounting bracket. Refer to CD Changer From Bracket Removal .

1. Install the compact disc (CD) changer (3) to the mounting bracket (2). Refer to CD Changer From Bracket Removal .



2. Connect the electrical connector (3).
3. Position the (CD) changer to the floor.
4. Slide the tabs on the bracket (3) into the slots in the floor.

Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

5. Install the 2 bolts (1) to the front of the bracket into the floor.

Tighten
Tighten the fasteners to 9 N·m (80 lb in).

6. Close the rear compartment lid.