Removal Procedure
- Open the driver door.
- Remove the fasteners (2) in order to disengage the insulator (3) from the lower instrument panel.
- Disconnect the electrical connector.
- Slide the insulator panel rearward in order to clear the emergency brake bracket.
- Remove the insulator panel.
Installation Procedure
- Position the insulator panel (3) to the retainer studs (1, 4) under the instrument panel.
- Push forward in order to secure the insulator panel to the retainer studs.
- Connect the electrical connector.
- Push the electrical connections forward.
- Lift upward on the insulator panel.
- Install the fasteners to the insulator panel.
- Close the driver door.
Important: Make sure the forward edge of the insulator is properly installed onto the retainer studs (1, 4) at the front of the dash. Failure to properly install the insulator panel may result in brake pedal and/or accelerator pedal binding.
Important: Ensure all electrical connections are pushed forward in order to prevent interference with the insulator.
Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.
Tighten
Tighten the fasteners to 2 N·m (18 lb in).
