Tools Required

J 39346-A Mini-Wedge Striker Aligner

Caution: Striker alignment is crucial for proper operation of the door systems. Do not hit the striker with a hammer or force alignment in any other way. Failure to properly adjust striker will result in excessive door efforts or extensive damage to door system operation which could result in personal injury.

Notice: Striker alignment is a crucial part of door latch operation. Do not use the door striker to adjust the door to the vehicle. Failure to properly adjust the striker can result in damage to the door latch and the striker.

Important: Before adjusting the mini wedge striker, align the door with the body. Refer to Door Adjustment .

Important: Observe the following conditions before removing the striker (3) :

•	The striker position

•	The number of spacers

1. Remove the 2 mini wedge striker fasteners (4).
2. Remove the following components:

•	The mini wedge striker (3)

•	The spacer (2)

•	The washer (1)

1. Assemble the following components:

•	The washer (1)

•	The spacer (2)

•	The striker (3)

2. Position the striker on the lock pillar using the narrow part of the wedge outboard.
3. Install the striker fasteners (4) in order to secure the striker.

Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

4. Tighten the 2 striker fasteners (4).

Tighten
Tighten the fasteners to 27 N·m (20 lb ft).

5. Remove the mini-wedge door striker aligner. Refer to J 39346-A .
6. Touch up any exposed unpainted surfaces on the lock pillar with body color paint.