The following text and illustrations describe the details of the required scheduled maintenance services.

For time and/or mileage intervals of scheduled maintenance items, refer to Maintenance Schedule .

For information on the proper fluids and lubricants to use, refer to Fluid and Lubricant Recommendations .

Change both the engine oil and the filter according to the maintenance schedule intervals.

For time and/or mileage intervals of scheduled maintenance items, refer to Maintenance Schedule .

Engine Oil Quality

Oils recommended for the vehicle can be identified by looking for the STARBURST symbol. This symbol indicates that the oil has been certified by the American Petroleum Institute (API).

Engine Oil Viscosity

Notice: Using oils of any viscosity other than those recommended could result in engine damage. When choosing an oil, consider the range of temperatures the vehicle will be operated in before the next oil change. Then, select the recommended oil viscosity.

SAE 5W-30 is the only viscosity grade recommended for your vehicle.

Use only oils which have the API Starburst symbol and which are also identified as SAE 5W-30.

If the temperature range is 0°F (-18°C) or above SAE 10W-30 oil which has the API Starbust symbol is acceptable if SAE 5W 30 oils is not available. Areas where the temperature falls below -20°F (-29°C), it is recommended either an SAE 5W-30 synthetic oil or and SAE 0W-30 oil. Both will provide easier cold starting and better protection for the engine at extremely low temperatures. Do not use other viscosity grade oils, such as SAE 10W-40 or SAE 20W-50 under any conditions.

Notice: Do not lubricate the parking brake cables. Lubrication destroys the plastic coating on the cable.

Important: Wipe off all dirt from the grease fitting before lubricating the joint. Ball joints should not be lubricated unless their temperature is -12°C (10°F) or higher. During cold weather, the ball joint should be allowed to warm up as necessary before being lubricated. Use a low-pressure grease gun on all joints to prevent seal damage.

Lubricate the transaxle shift linkage. Lubricate the parking brake guides, underbody contact points and linkage.

Apply grease slowly to the rear tie rod ends (1) while watching the grease seal. Apply grease until grease is seen bleeding from the seal. If the seal expands but no grease is seen, do not apply any more grease and allow time for the grease to bleed from the seal.

Check the tires for abnormal wear or damage. Refer to Tire Diagnosis - Irregular or Premature Wear in Tires and Wheels. Rotate the tires to equalize the wear and obtain maximum tire life.

Inspect the accessory drive belts for the following:

Replace accessory drive belt as needed. Belts can have many small cracks in individual ribs without affecting the performance.

Change both the fluid and the filter according to the maintenance schedule intervals.

For time and/or mileage intervals of scheduled maintenance items, refer to Maintenance Schedule .

For information on the proper fluids and lubricants to use, refer to Fluid and Lubricant Recommendations .

Replace the spark plugs according to the maintenance schedule intervals.

For time and/or mileage intervals of scheduled maintenance items, refer to Maintenance Schedule .

Clean the spark plug wires and inspect for burns, cracks or other damage. Check the wire boot fit at the coils and at the spark plugs. Replace spark plug wires as needed.

Replace the air cleaner filter according to the maintenance schedule intervals.

For time and/or mileage intervals of scheduled maintenance items, refer to Maintenance Schedule .

Inspect the following components for damage or leaks:

Inspect the fuel cap gasket for an even filler neck imprint and any damage. Replace parts as needed.

Periodic replacement of the fuel filter is not required.