The Radio control module and the Radio Antenna module cannot be replaced individually.

1. Lower the rear of the headliner. Refer to Headlining Trim Panel Replacement in Interior Trim.
2. Disconnect the wire harness (2) attached to the rear quarter glass panel.
3. Remove the module (3) retaining bolt.



4. Disconnect the antenna cable from the module.
5. Remove the antenna module from the roof.
6. Remove the radio control module. Refer to Radio Control Module Replacement .

1. Install the radio control module. Refer to Radio Control Module Replacement .
2. Install the antenna module to the roof.




Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

3. Install the module retaining bolt.

Tighten
Tighten the retaining bolt to 9 N·m (80 lb in).

4. Connect the antenna cable to the module (3).
5. Connect the wire harness (2) to the rear quarter glass panel.
6. Install the rear of the headliner. Refer to Headlining Trim Panel Replacement in Interior Trim.