The Driver Door Switch (DDS) and Passenger Door Switch (PDS) control the power folding or power extending functions of the outside rearview mirrors. The folding mirror motors are controlled by using bi-directional motor controls through the folding mirror motor retract control circuit and the folding mirror motor extend control circuit.

Schematic Reference

Outside Rearview Mirror Schematics

Connector End View Reference

Vehicle Access Connector End Views

Description and Operation

Outside Mirror Description and Operation

Electrical Information Reference

1. Ignition ON, observe the scan tool Mirror Fold Switch parameter while cycling the mirror fold switch between the extend and retract positions. The parameter should change between Idle, Extend, and Retract.

⇒	If the parameter does not cycle between the specified values, replace the DDS.

2. Command the power folding mirrors to extend and retract using the mirror fold switch. Both mirrors should extend and retract as commanded.

1. Ignition OFF, disconnect the harness connector C7 at the appropriate door switch.
2. Ignition ON, verify a test lamp does not illuminate between the following circuit terminals and ground:

•	Control circuit terminal 1

•	Control circuit terminal 2

⇒	If the test lamp illuminates, test the appropriate circuit for a short to voltage.

3. Ignition OFF, test for infinite resistance between the following circuits and ground:

•	Control circuit terminal 1

•	Control circuit terminal 2

⇒	If less than the specified value, test the appropriate circuit for a short to ground. If the circuits test normal, test or replace the rearview mirror motor.

4. Test for 5-15 ohms of resistance between the control circuit terminal 1 and the control circuit terminal 2.

⇒	If not within the specified range, test both control circuits for an open/high resistance. If the circuits test normal, test or replace the rearview mirror motor.

5. If all circuits test normal, replace the appropriate door switch.

Perform the Diagnostic Repair Verification after completing the diagnostic procedure.