Caution: When working with any type of glass or sheet metal with exposed or rough
edges, wear approved safety glasses and gloves in order to reduce
the chance of personal injury.
Caution: If a window is cracked but still intact, crisscross the window with
masking tape in order to reduce the risk of damage or personal injury.
Important: Before cutting out a stationary window, apply a double layer of masking tape around the perimeter of the painted surfaces and the interior trim.
- Open the liftgate.
- Remove the right or left side rear applique. Refer to
Quarter Panel Upper Applique Replacement
.
- Remove the rear door upper garnish trim. Refer to
Rear Door Upper Garnish Molding Replacement
.
- Disconnect the electrical connector from the quarter window.
Caution: If broken glass falls into the defroster outlets, it can be blown into
the passenger compartment and cause personal injury.
- Cover the following parts to protect from broken glass:
| 5.2. | The defroster outlets and A/C outlets |
| 5.3. | The seats and the carpeting |
Important: Keep the cutting edge of the tool against the quarter window from inside the vehicle. This will allow the urethane adhesive to be separated from the window.
- Use
J 24402-A
,
J 39032
, or equivalent in order to remove the quarter window.
| • | Leave a base of urethane on the pinchweld flange. |
| • | The only suitable lubrication is clear water. |
Important: If the antenna on the quarter is damaged, replace the quarter window.
- With the aid of an assistant, use the suction cups to remove the window from the opening.
