Caution: Refer to Brake Dust Caution in the Preface section.

1. Disable the park brake cable automatic adjuster. Refer to Parking Brake Cable Adjuster Disabling .



2. Disconnect the park brake cable from the park brake actuator lever.
3. Remove the park brake shoe. Refer to Parking Brake Shoe Replacement .
4. Remove the rear axle shaft. Refer to Rear Axle Shaft Replacement .



5. Remove the park brake backing plate bolts.
6. Remove the park brake backing plate from the disc brake backing plate.

1. Install the park brake backing plate to the disc brake backing plate.
2. Perform the following procedure before installing the park brake backing plate bolts.

2.1.	Remove all traces of the original adhesive patch.

2.2.	Clean the threads of the bolt with brake parts cleaner or the equivalent and allow to dry.

2.3.	Apply Threadlocker GM P/N 12345493 (Canadian P/N 10953488) to the threads of the bolt.

Notice: Refer to Fastener Notice in the Preface section.

3. Install the park brake backing plate bolts.

Tighten
Tighten the bolts to 135 N·m (100 lb ft).

4. Install the rear axle shaft. Refer to Rear Axle Shaft Replacement .
5. Install the park brake shoe. Refer to Parking Brake Shoe Replacement .



6. Connect the park brake cable to the park brake actuator lever.
7. Enable the park brake cable automatic adjuster. Refer to Parking Brake Cable Adjuster Enabling .
8. Adjust the park brake shoe. Refer to Park Brake Adjustment .