Replace the wheel if any of the following conditions exist:
| • | The wheel exhibits excessive runout. |
| • | The wheel is severely rusted. |
| • | The wheel is severely corroded. |
| | Important: Air leaks caused by porosity on aluminum wheels are repairable.
|
| | Caution: If you are replacing the wheel(s), the wheel stud(s), the wheel nut(s)
or the wheel bolt(s), install only new GM original equipment parts. Installation
of used parts or non-GM original equipment parts may cause the wheel to loosen,
loss of tire air pressure, poor vehicle handling and loss of vehicle control
resulting in personal injury.
|
Notice: The use of non-GM original equipment wheels may cause:
| • | Damage to the wheel bearing, the wheel fasteners and the wheel |
| • | Tire damage caused by the modified clearance to the adjacent vehicle
components |
| • | Adverse vehicle steering stability caused by the modified
scrub radius |
| • | Damage to the vehicle caused by the modified ground clearance |
| • | Speedometer and odometer inaccuracy |
Replace the wheel, the wheel studs and the wheel/nuts, or the wheel bolts if
applicable, if any of the following conditions exist:
| • | The wheel has elongated bolt holes. |
| • | The wheel/nuts, or bolts if applicable, loosen repeatedly. |
Steel wheel identification is stamped into the wheel near the valve stem.
Aluminum wheel identification is cast into the inboard side of the wheel.
