1. Escalade Rear Access Panel

   
   
   

   Retaining Bracket and Wing Nut

2. Tool Kit and Jack Tools

3. Wing Nut Holding Wheel Blocks

4. Wheel Blocks

5. Jack

6. Knob

For Escalade, the equipment is located behind the left trim panel in the rear of the vehicle.

To access and remove the tools, do the following:

1. Unlatch the release lever to open the trim panel door.
2. Release the jack (E) from its holder by turning the knob on the jack counterclockwise to lower the jack head.
3. Remove the wing nut (A) used to retain the tool kit (B) by turning the wing nut counterclockwise.
4. Remove the wheel blocks (D) and the wheel block retainer by turning the wing nut (C) counterclockwise.

1. Escalade ESV

   
   
   

   Knob

2. Removable Tray

3. Retaining Hook

4. Retaining Bracket and Wing Nut

5. Tool Kit and Jack Tools

6. Mounting Bracket

7. Wing Nut Holding Wheel Blocks

8. Wheel Blocks

9. Jack

For Escalade ESV, the equipment you will need is under the storage tray in the left trim panel.

To access and remove the tools, do the following:

1. Remove the tray (B) to access the tools.
2. Release the jack (I) from its holder by turning the knob (A) on the jack counterclockwise to lower the jack head.
3. Remove the wing nut used to retain the tool kit (E) by turning the wing nut counterclockwise.
4. Remove the wheel blocks (H) and the wheel block retainer by turning the wing nut counterclockwise.

You will use the jack handle extensions and the wheel wrench to remove the underbody-mounted spare tire.

To remove the spare tire, do the following:

1. 
   
   

   Spare Tire (Valve Stem Pointed Down)

2. Hoist Assembly

3. Hoist Cable

4. Tire Retainer

5. Hoist Shaft

6. Hoist End of Extension Tool

7. Hoist Shaft Access Hole

8. Wheel Wrench

9. Jack Handle Extensions

10. Spare Tire Lock (If Equipped)

1. Open the spare tire lock cover on the bumper and use the ignition key to remove the lock if your vehicle is equipped with a spare tire lock (J).



2. Assemble the wheel wrench (H) and the two jack handle extensions (I) as shown.




Insert the hoist end (open end) (F) of the extension through the hole (G) in the rear bumper.

3. Be sure the hoist end of the extension connects to the hoist shaft (E). The ribbed square end of the extension is used to lower the spare tire.
4. Turn the wheel wrench (H) counterclockwise to lower the spare tire (A) to the ground. Continue to turn the wheel wrench until the spare tire can be pulled out from under the vehicle.

If the spare tire does not lower to the ground, the secondary latch is engaged and preventing the tire from lowering. See Secondary Latch System for instructions on lowering the spare tire.





Use the wheel wrench hook that allows you to pull the hoist cable (C) towards you to assist in reaching the spare tire.





Tilt the retainer at the end of the cable when the tire has been lowered, so it can be pulled up through the wheel opening.

5. Put the spare tire near the flat tire.