Important: Use care when handling the mass air flow(MAF)/intake air temperature (IAT) sensor. Do not dent, puncture, or otherwise damage the honeycell located at the air inlet end of the MAF/IAT. Do not touch the sensing elements or allow anything including cleaning solvents and lubricants to come in contact with them. Use a small amount of a non-silicone based lubricant, on the air duct only, to aid in installation.

1. Remove the intake air resonator. Refer to Intake Air Resonator Replacement .
2. Disconnect the MAF/IAT sensor electrical connector (3).



3. Loosen the MAF/IAT clamp.
4. Remove the MAF/IAT sensor from the air cleaner assembly.

Important:: The embossed arrow on the MAF/IAT sensor indicates the proper air flow direction. The arrow must point toward the engine.

1. Locate the air flow direction arrow (2) on the MAF/IAT sensor.

Notice: Refer to Fastener Notice in the Preface section.




2. Install the MAF/IAT sensor to the air cleaner assembly.
3. Tighten the MAF/IAT clamp.

Tighten
Tighten the clamp to 7 N·m (62 lb in).




4. Connect the MAF/IAT sensor electrical connector (3).
5. Install the air intake resonator. Refer to Intake Air Resonator Replacement .